Configuring A Paging Line - HPE FlexNetwork MSR Series Configuration Manual

Item
DTMF Detection Sensitivity
Level
Status

Configuring a paging line

Select Voice Management > Line Management from the navigation tree, and then click the
icon of the paging line to be configured to access the audio interface configuration page, as shown
Figure 737.
in
Figure 737 Configuring SIC-audio page interface
Table 276 Configuration items
Item
Line Description
Voice Interface Output
Gain
Silent Mode
Description
Set the DTMF detection sensitivity level.
•
Low—In this mode, the reliability is high, but DTMF tones might fail to
be detected.
•
High—In this mode, the reliability is low and detection errors might
occur.
•
Enable.
•
Disable.
Description
Specify the description of the paging line.
When a relatively small voice signal power is needed on the output line, increase
the voice output gain value.
IMPORTANT:
Gain adjustment might lead to call failures. Hewlett Packard Enterprise
recommends not adjusting the gain. If necessary, do it with the guidance of
technical personnel.
•
Enable.
•
Disable.
By default, the silent mode is disabled.
IMPORTANT:
If the silent mode is enabled on an audio interface, the interface cannot transmit
data.
357