Fakir CL 220 Dry Type Instruction Manual page 35

d) Changing the Motor
Protection Filter
e) Cleaning
MAINTENANCE
1) Switch off the vacuum cleaner and remove the the dust filter
bag as described in 6/a.
2) Remove the filter holder with motor protection filter (Fig. 22)
slightly pres it down and pull the filter forwards and out.
3) Remove the motor protection filter from the filter holder over
a dustbin (Fig. 23).
4) Clean thefilter holder.
5) If the new motor protection filter is too large, lay the old filter
onto the new filter mat. Mark the contours and cut the new filter
Fig. 22
down to size with a pair of scissors.
6) Insert the new motor protection filter into the filter holder.
7) Insert the filter holder with the new filter into its bracket from
above and push it down until it audibly locks into place.
8) Replace the dust filter bag and close the dust compartment
cover. The cover clicks into place audibly.
Fig. 22
Always switch off the appliance and disconnect it from
the mains before cleaning it.
do not use cleaning or scouring agents or alcohol, as
these might damage the appliance.
Clean the outside of the housing using a slightly damp cloth
only.
WARNING!
ATTENTION!
GB
35