Operation - Fakir CL 220 Dry Type Instruction Manual

OPERATION

a) Vacuum Cleaning
Check the vacuum cleaner and the power cord each time
before using it. A damaged appliance must not be used.
There is danger of injury.
Fig. 10
Only use the vacuum cleaner with all fitler intact, in dry
condition and correctly placed. Make sure that the openings
of the vacuum cleaner are not clogged or obstructed.
Otherwise the vacuum cleaner might be damaged.
Your vacuum cleaner is equipped with a safety switch to
prevent overheating. It automatically cuts off the power supply
if the motor is overheated. In this case switch off the vacuum
Fig. 11
cleaner and disconnect it from the mains. Remove the cause
of the overheating. Wait for about 45 minutes. After it has
cooled off, you may use the vacuum cleaner again.
1) Attach the desired nozzle.
2) Pull out the cord until the yellow mark is visible (Fig. 10/1).
If the red marking shows (Fig. 10/2) retract the cord by
pressing the retract button to pull in the cable (Fig. 11/2)
Fig. 12
up to the yellow mark again.
3) Switch on the vacuum cleaner with the on/off switch (Fig. 11/1)
4) Set the nozzle switch to "carpet" or "hard floor" according to the floor
(Fig. 12) to be cleaned:
- Hard floor: Laminate, tiles, PVC, etc.
- Carpet: Short-and deep-pile carpets, rugs, etc.
With the bypass vent (Fig. 13/1) you can quickly reduce the
Fig. 13
suction power if less power is nede, or to release objects
accientally sucked in.
WARNING!
ATTENTION!
NOTICE!
WARNING!
NOT!
GB