Table of Contents
Advertisement
HR Series
Operating & Safety Instructions
4.2.2
OPERATION
ALWAYS ALLOW THE ENGINE TO WARM UP BEFORE OPERATING.
ALL MODELS
1)
Ensure all red emergency stops are out.
2)
Turn Base/Platform selector at ground control station to Ground (Clockwise).
3)
For Battery powered operation, go to step 7).
4)
For Diesel powered operation, go to step 5).
DIESEL ENGINE
5)
COLD ENGINE: - turn the Diesel Glow/Start selector to the Glow position (anti-clockwise). This
engages the glow plug pre-heat system. Hold for 10 seconds then turn the key to the Start
position (fully clockwise) and the engine will fire.
6)
WARM ENGINE: - turn the Diesel Glow/Start selector to the Start position (clockwise) and the
engine will fire.
Note: Unless the diesel engine is running, the HR21 Hybrid will automatically default to the electrical
power source (battery).
ALL MODELS
7)
Push and hold green power button on the base control box.
8)
Select a function and operate the appropriate hydraulic lever in full accordance with
manufacturers operating and safety manual.
Note: Move lever until resistance is felt, then push/pull harder to activate function.
9)
To return control to the platform turn the Base/Platform selector to the Platform position (anti-
clockwise).
10)
When not in use return machine to stowed position, turn the Base/Platform selector to centre
Off position, remove key and chock wheels.
EMERGENCY PROCEDURES
1)
Push in red emergency stop to shut down all functions.
2)
In the event that the controls fail or the operator becomes incapacitated the booms can be
operated by using the hand pump which is located under the canopy next to the base controls.
To operate:
a)
b)
c)
26
Move and hold lever to be operated.
Use hand pump lever to move machine.
Release control lever to halt machine movement.
English/USA – 11/09
Original Instructions
Hide quick links:
Advertisement
Table of Contents
