Inverters Of 18.5 Kw Or Higher; Mounting The Digital Operator - Saftronics VG520P4 Technical Manual

Chapter 2: Handling Inverters
§

Mounting the Digital Operator

1. Hook the Digital Operator at A (two locations) on the front cover in the direction of arrow 1 as shown in the
following illustration.
2. Press the Digital Operator in the direction of arrow 2 until it snaps in place at B (two locations).
•
Do not remove or attach the Digital Operator or mount or remove the front cover using methods other then those described
NOTE:
above, otherwise the Inverter may break or malfunction due to imperfect contact.
•
Never attach the front cover to the Inverter with the Digital Operator attached to the front cover. Imperfect contact can
result.
•
Always attach the front cover to the Inverter itself first, and then attach the Digital Operator to the front cover.
2.5.2

Inverters of 18.5 kW or Higher

The front cover can be removed without removing the Digital Operator from the Inverter provided that the Inverter has an
output of 18.5 kW or higher.
Loosen the four screws of the front cover and move the front cover slightly upward to remove the front cover.
Firmware – S1043
Revision: 2 (9/98)
Figure 2.4 Mounting the Digital Operator
17
© Saftronics, Inc.