Chapter 2: Handling Inverters
2.4
Installation Orientation and Space
Install the Inverter on a vertical surface so as not to diminish its coding efficiency. When installing the Inverter, always provide the
following installation space to allow normal heat dissipation.
•
NOTE:
The same space is required horizontally and vertically for both open chassis (IP00) and enclosed wall-mounted (IP20,
NEMA 1) Inverters.
•
Always remove the protection covers before installing a 200 or 400 V class Inverter with an output of 15 kW or less in a
panel.
•
Always provide enough space for suspension eyebolts and the main circuit lines when installing a 200 or 400 V class
Inverter with an output of 30 kW or more in a panel.
Firmware – S1043
Revision: 2 (9/98)
Figure 2.1
VG5 Installation Orientation and Space
15
© Saftronics, Inc.