Saftronics VG520P4 Technical Manual page 19

Chapter 1: Introduction
Key
LOCAL/REMOTE Key
MENU Key
ESC Key
JOG Key
FWD/REV Key
RESET Key
Increment Key
Decrement Key
DATA/ENTER Key
RUN Key
STOP Key
Note: Except in diagrams, keys are referred to using the key names listed in the above table.
Firmware – S1043
Revision: 2 (9/98)
Table 1.4 Key Functions
Name
Switches between (LOCAL) operation via the Digital Operator and control circuit terminal
(REMOTE) operation. This key can be enabled or disabled by setting a user constant
(o2-01).
Displays menus.
Returns to the status before the DATE/ENTER key was pressed.
Enables jog operation when the VG5 is being operated from the Digital Operator.
Selects the rotation direction of the motor when the VG5 is being operated from the
Digital Operator.
Sets the number of digits for user constant settings. Also acts as the reset key when a
fault has occurred.
Selects menu items, groups, functions, and user constant names, and decrements set
values.
Selects menu items, groups, functions, and user constant names, and decrements set
values.
Enters menu items, functions, constants, and set values after they are set.
Starts the VG5 operation when the VG5 is in operation with the Digital Operator.
Stops VG5 operation. This key can be enabled or disabled by setting a user constant
(o2-02) when operating from the control circuit terminal.
Figure 1.5
Function
RUN and STOP Indicators
8
© Saftronics, Inc.