Product Description; Assembly And Installation - TeachLogic Quantum II Owner's Manual

Quantum II
owner's manual

product description

The Quantum II is an infrared wireless microphone
sound system. It is the nucleus of the classroom
sound field system which provides optimum voice
reinforcement.
The addition of a Quantum II sound system will
transform your classroom into a totally hands free,
voice re-enforcement system, resulting in reduced
voice fatigue, enhanced student listening and
improved student learning. The wireless function
permits 360° connectivity throughout the classroom
regardless of body position or orientation.
The system is comprised of an infrared detecting
sensor. The sensor collects the IR wireless signal
from the microphone/transmitter and sends a
composite signal to the mixer/amplifier. The
receiver transforms the composite signal into an
analog audio signal which is fed to the Quantum
II mixer. An additional audio sources, such as;
computer, DVD, VCR or Projector can be plugged
in to the Quantum II. The AUX IN level controls the
individual audio input. The audio will then be fed to
the speaker in the column for voice reinforcement
throughout the room.
On the front panel of the Quantum II, there is a
3.5mm output jacks for interface with an assistive
listening system (ALS) or lesson capture (LINE
OUT).
The microphone / transmitter can be one or two
Sapphire Pendants or Handhelds. The rechargeable
batteries will provide 6 – 8 hours of service per
charge. The drop-in charger will recharge the
batteries overnight, ready for another day's use.
2
Reliable
performance.
Use with
confidence.
2

assembly and installation

Mounting the Quantum II on the wall, please review the following guidelines.
• Selecting the most appropriate location for the Quantum can be the
most challenging. Every room is a little different, but in general the most
functional location is installing it on the front wall off to one side or the other
approximately from either side wall.
• An alternate choice would be on either side wall, located approximately ¼
the distance from the front of the room.
NOTE: Be conscious of an AC outlet requirement for power.
• Once you've decided where to mount the Quantum II, hold the 'U' bracket
straight up and down against the wall with bottom of the bracket approximately
5-6 feet above the floor. Using a level to assure true vertical orientation, mark
the two mounting holes.
• If installing onto a drywall, drill two ¼" holes and insert a molley bolt
provided. With a #2 Phillips head screwdriver, mount the wall bracket.
• If installing into a wood or like material, use two sheet metal screws with
washers to mount the bracket to the wall.
• For concrete wall, you'll need to acquire and install a plastic insert for a # 8
sheet metal screw and install accordingly.
• With the bracket mounted, route the plastic wire tie through the two tab
holes. Hold the power supply onto the two raised tabs with the AC plug end
toward the floor. With the power supply resting on the pegs, tighten the wire
tie thus securing the power supply to the bracket.
• Insert the DC plug into the power input jack and place the Quantum II into
the bracket, secure each end with the bolt and washer provided.
• Orient the Quantum with center pointing diagonally across the listening
area.
• Plug the power cord into an AC outlet
The Quantum II can be operated as a free stance system on a speaker stand.
To use in this mode of operation:
• Locate the system off to one side in the front of the room. Point the front
of the unit toward the center of the listening area. Find an AC outlet and plug
the system in.
• Side wall location is also acceptable. Locate unit on either side about ¼
from front of room. Point the front diagonally across the listening area. Locate
an AC outlet and plug it in.
Optional: Folding Tripod Stand SS-300
3