Chain Adjustment; Seasonal Storage - Poulan Pro 115261226 Instruction Manual

8. Place chain over sprocket, fitting the drive
links in the sprocket.
9. Fit bottom of drive links between the teeth in
the sprocket in the nose of the guide bar.
10. Fit chain drive links into bar groove.
11. Pull guide bar forward until chain is snug
in guide bar groove. Ensure all drive links
are in the bar groove.
USER REPLACEABLE SERVICE PARTS
Use only recommended user replaceable service parts as listed below:
REPLACEMENT PART
Bar
Chain
Hex Nut
Oil Cap
Bar Adjusting Screw/Pin Kit
WARNING:
Perform the following
steps after each use:
S Allow attachment to cool before storing or
transporting.
S Store attachment with all guards in place.
Position attachment so that any sharp ob-
ject cannot accidentally cause injury.
S Store the attachment in a dry, well venti-
lated area out of the reach of children.

SEASONAL STORAGE

Prepare attachment for storage at end of sea-
son or if it will not be used for 30 days or more.
12. Now, install bar clamp making sure the
adjusting pin is positioned in the lower
hole in the guide bar.
Guide Bar
13. Install bar clamp nut and finger tighten
only. Do not tighten any further at this
point. Proceed to the CHAIN ADJUST-
MENT section.

CHAIN ADJUSTMENT

See CHECK CHAIN TENSION in MAINTE-
NANCE section.
PART NUMBER
530044908
952051549
530015917
530053072
530069611
STORAGE
If your pruner attachment is to be stored for a
period of time:
S Clean the entire attachment.
S Lightly oil external metal surfaces and
guide bar.
S Oil the chain and wrap it in heavy paper or
cloth.
S Check entire attachment for loose screws
or nuts. Replace any damaged, worn or
broken parts.
S At the beginning of the next season, use
only fresh fuel having the proper gasoline to
oil ratio.
13
Lower Hole
Adjusting Pin