Chain Adjustment; Replacing The Line - Poulan Pro 115244926 Instruction Manual

Cutter
Tip of
Bar
Drivelink
CUTTERS MUST FACE IN
DIRECTION OF ROTATION
Cutters
Drive Links
8. Place chain over sprocket, fitting the
drive links in the sprocket.
9. Fit bottom of drive links between the teeth
in the sprocket in the nose of the guide
bar.
10. Fit chain drive links into bar groove.
11. Pull guide bar forward until chain is snug
in guide bar groove. Ensure all drive links
are in the bar groove.
12. Now, install bar clamp making sure the
adjusting pin is positioned in the lower
hole in the guide bar.
Adjusting Pin
Guide Bar
13. Install bar clamp nut and finger tighten
only. Do not tighten any further at this
point. Proceed to the CHAIN ADJUST-
MENT section.

CHAIN ADJUSTMENT

See CHECK CHAIN TENSION in MAINTE-
NANCE section.

REPLACING THE LINE

1. Press the tabs on the side of the trimmer
head and remove cover and spool.
Depth Gauge
Tab
Cover
2. Remove any remaining line.
3. Clean dirt and debris from all parts. Re-
place spool if it is worn or damaged.
4. Replace with a pre-wound spool, or re-
place line using a 25 feet (8 meters)
Lower
length of 0.080 inch (2 mm) diameter
Hole
Poulan PRO brand line.
WARNING:
string, etc., which can break off and become a
dangerous missile.
5. When installing new line on an existing
spool, hold the spool as shown.
6. Bend the line at the midpoint and insert
the bend into the slot in the center rim of
the spool. Ensure line snaps into position
in the slot.
20
Tab
Spool
Never use wire, rope,