Windsor FILTRONIC F22 Owner's Manual page 3

Battery Maintenance:
When cleaning batteries use a solution of baking
(Do
soda and water.
enter inside battery cells.)
Keep a proper electrolyte level in battery cells.
Wipe down the battery tops at least once a
If a cell should accidently overflow, clean
immediately.
Test battery condition with a hydrometer at least
once a week.
Ensure that all connections are tight and that all
corrosion is removed.
Every 4 to 6 months remove batteries from the
machine and clean the battery compartment.
Spare Parts and Accessories:
00
021 Hydrometer
Post
02101 Battery Cleaner
02143 Battery, 12V DC, 20 Amp, 185 Amp Hour
02104 Charger, 36V DC 20 Amp, Auto Shut-Off
02141 Charger, 36V DC 20 Amp, Auto Shut-Off
(1 OOV Hz)
02142 Charger, 36V DC 20 Amp, Auto Shut-Off
02155 Charger, 36V DC 20 Amp, Auto Shut-Off
Hz)
021 63 Charger, 36V DC 20 Amp, Auto Shut-Off
Hz)
25 Cable, 12" Red
231
78231 Battery Tray
not allow cleaning fluid to
week.
Battery Charging Procedure:
Charge the batteries once the amber charge level light
about 20% charge left in the batteries.
batterles completely drain before charglng. Avoid
charging the batteries before the amber light comes
on. The machine will run for hours on fully charged,
well maintained batteries.
WARNING:
DO NOT SMOKE, HAVE OPEN FLAMES, OR
SPARKS NEAR BATTERIES AT ANY TIME.
WEAR EYE PROTECTION AND PROTECTIVE
CLOTHING WHEN WORKING WITH BATTERIES.
CHARGE BAlTERlES IN A WELL VENTILATED
AREA WITH DECK DOWN AND COVER OPEN.
1 .) Use a 36 volt, 20 amp maximum output, D.C.
charger which turns itself off, when the batteries are
fully charged. The charger must have a connector
that matches the machines battery connection.
2.) Read the instructions and warnings provided by
the battery charger manufacturer.
in a well ventilated area on a lev-
3.) Set the charger
el surface. Make sure cords will easily reach outlets
on both machine and wall.
Connect charger to D.C. outlet on machine
4.)
first.
5.) Connect the A.C. power cord to properly
grounded wall socket. NEVER MAKE THE A.C.
CONNECTION FIRST, HAZARDOUS SPARKS MAY
RESULT.
6.) After the batteries are completely charged discon-
nect the charger from the A.C. wall socket.
7.) Once the charger is disconnected from the A.C.
wall socket it is safe to disconnect the charger from
the machine.
8.) When the batteries
are fully charged, check the
electrolyte level by removing
the caps on top of the
batteries. If necessary fill the
cells with distilled water as
shown in the diagram to the
right. Be careful not to overfill
cells.
Page 3 of 20
Do not let the
--
3