Table of Contents
Advertisement
LGIC CDMA Fixed Wireless Terminal
LST-200/2200
Installation
STEP I. Check Components
l
Each standard unit comes with the Fixed Wireless Terminal, an AC power supply with
power cords, an antenna, a Battery and User Manual.
l
Please make sure that these components are present and check for evidence of shipping
before you begin the unit installation. If components are missing or damage is found,
contact your authorized LGIC distributor immediately.
STEP II. Place the Terminal
l
Place the terminal on the stable flat secure surface area (desk, table, etc.). Avoid direct
exposure to the sun lights and damp area.
l
Read the SAFETY INFORMATION located at the first part of this document before you
place the terminal.
STEP III. Connect Components
l
Connect the antenna to the TNC connector located at the topside of the terminal. (See
Figure 1 to locate the TNC connector.) If you placed the terminal on the flat surface, bend
the antenna up right.
l
Connect your phone cord to the RJ-11C port located at the left side of the terminal.
l
Connect the AC power supply cable to the DC input port located at the right side of the
terminal.
l
If you use Data Service or PC FAX Service, connect your RS-232C cable cord to the DB9
port located at the right side of the terminal.
l
If you use G3 FAX machine, connect your line cord of G3 FAX to the RJ-11 port located
at the right side of the phone port.
" Refer to Connection Diagram with external equipment in Figure 2 "
STEP IV. Check LED indicators
l
When you followed the installation instruction STEP I to STEP III, please check the LEDs
for normal operation.
STEP V.
Wall Mounting Bracket
l
The terminal comes with a bracket for wall installation. Before installing it, determine
the location which provides the strongest signal and a near by electrical outlet.
1. Hold the bracket against the wall;
2. Mark the two openings and select round or panhead type screw;
3. Drill out the holes with drill bit smaller in diameter than the screws
4. Secure two screws into the wall, leaving about 1/8inch gap between the screw heads
11
Advertisement
Table of Contents
