Table of Contents
Advertisement
YellowjacketPLUS Startup Screen
Getting Started
The YellowjacketPLUS 802.11a software can be started by:
1.
Pressing the Start button on the Ipaq.
2.
Pressing the "Yellow Jacket A" program option from
the main drop-down list.
3.
Tapping anywhere on the screen when the splash
screen appears as shown below.
YellowjacketPLUS Main Screen
The main menu of the YellowjacketPLUS software contains
option buttons in the main viewing area and a series of tool-
bar options. The main viewing area is shown below. There are
three choices in the main viewing area. You may choose spec-
trum analysis, which enters a
which will show all RF being received within the range of the
receiver. This mode also allows for zooming in to a particular
channel.
The next option is the
the user to view individual access points being seen by the
receiver and then to proceed to Geiger mode for locating the
particular access point.
The next option is the
screen provides the user with a list of access points that are
seen by the receiver. The user can then "zoom in" on a par-
ticular access point for further analysis as well as for pinpoint-
ing the AP's location.
The final menu option is the
receiver has locked to several GPS satellites, his screen dis-
plays vital GPS information such as LAT, LON, ALT, etc.
The
toolbar
gives the user more options on every screen. The
first icon (from left to right) has five interconnected colored
circles. Using this option will always return the user to the
main menu. The second and third icons are arrows pointing
upward and downward. These options have different uses
depending on the currently active screen. For instance, on
spectrum analyzer-type screen
access point
screen. This will allow
MAC list
screen. The access point list
GPS Data
screen. When the GPS
Page 4
Advertisement
Table of Contents
