Rotolight AEOS User Manual page 6

AEOS BASIC OPERATION
To operate AEOS you will fi nd two red rotary
controls, which are also switches, and a DC on/off
switch, these are all located on the rear of AEOS.
POWER
AEOS can be powered by 1 x V-Lock battery, DC
from the supplied AC mains Adapter or from a DC
source in the range of 7v -15v (i.e. optional Car 12v
Socket, or D-TAP from a broadcast battery). When
connecting a power source to the DC input socket,
for instance mains adapter or an optional D-Tap to
DC connection, the V-Lock battery is automatically
disconnected, thus saving battery power. NB if you
are connecting an external DC source make sure
the power is the correct polarity, to avoid damaging
your AEOS. We recommend using Rotolight RL-
Batt-95, 95mWh V-Lock batteries (available from
Rotolight.com) which will run your AEOS for up to 3
hours at full power.
To power up AEOS click the power switch (located
above the 'FLASH' input Jack)
On power up, you will see 'ROTOLIGHT AEOS' scroll
across the screen, you can interrupt this anytime by
operating one of the control knobs.
To power AEOS down , click the power switch again.
NB – AEOS stores all the user settings in non-volatile
RAM so it will remember your last used settings.
RESET
You can reset all the user parameters in AEOS
non-volatile memory by holding down the left red
control switch whilst simultaneously powering
AEOS ON.
The word 'ZERO' will be displayed, select Y for yes
ZERO
(reset all data), or N for NO.
06