Ickle Bubba Stomp Manual
  1. Manuals
  2. Brands
  3. Ickle Bubba Manuals
  4. Car Seat
  5. Stomp
  6. Manual

Ickle Bubba Stomp Manual

Child car seat group 0+
Hide thumbs Also See for Stomp:

Advertisement

Table of Contents

ECE 4 . 04
4
Approved
CHILD CAR SEAT
Group 0+
Rearward Facing
Weight Suitable for 0 to 13kg
Age From Birth to 13/15 months approx
For the safety of your baby, please read this user
guide carefully before use and follow accordingly.

Advertisement

Table of Contents
loading

Related Manuals for Ickle Bubba Stomp

Summary of Contents for Ickle Bubba Stomp

  • Page 1 ECE 4 . 04 Approved CHILD CAR SEAT Group 0+ Rearward Facing Weight Suitable for 0 to 13kg Age From Birth to 13/15 months approx For the safety of your baby, please read this user guide carefully before use and follow accordingly.
  • Page 2 INSTRUCTIONS FOR FITTING AND USE NOTICE 1. This is a "Universal" child restraint; it is approved to ECE Regulation 44.04 for general use in vehicles and will fit most, but not all vehicle seats. 2. A correct fit is likely if the vehicle manufacturer has declared in the vehicle handbook that the vehicle is capable.
  • Page 3 SAFETY WARNINGS 1. PLEASE READ THOROUGHLY BEFORE COMMENCING INSTALLATION AS AN INCORRECT INSTALLATION COULD BE DANGEROUS 2. PARENTS SHOULD NOT UNDER ANY CIRCUMSTANCES USE THIS CHILD RESTRAINT ON A PASSENGER SEAT EQUIPPED WITH AN ACTIVATED AIRBAG. HOWEVER, IF YOU NEED TO INSTALL THE SEAT IN THE FRONT PASSENGER SEAT PLEASE ENSURE THAT ANY AIRBAG IS DEACTIVATED.
  • Page 4 SAFETY WARNINGS 16. This seat can be used for children of 0-13kg in weight and is used in conjunction with a 3-point lap and diagonal safety belt in the rear-facing position only. 17. When the child seat is not in use, it is recommended that it is fastened into the car with a seat belt to avoid injury in the event of an accident.
  • Page 5 GETTING TO KNOW YOUR CHILD CAR SEAT 1. Handle Adjuster 8. Lap Belt guide 2. Pull Strap 9. Diagonal Belt Guide 3. Central adjuster 4. Child Car Seat Fabric Covering 10.Shoulder Harness Slots 5. Harness Buckle 11.Adapter (Travel System 6. Shoulder Straps Use) 7.
  • Page 6 LOOSEN THE SHOULDER STRAPS LOOSEN THE SHOULDER STRAPS PRESS PRESS 1. Open the harness buckle (press the red release button). 2. Place your baby into the baby seat. 3. Put the shoulder straps over the shoulders of your baby. Caution! Do not twist or interchange the shoulder straps. THE HARNESS CLICK Press...
  • Page 7 THE HARNESS Step C. Always check that the harness is correctly locked by pulling above and below the buckle. (Fig 3) Caution! Tighten the straps until they are in contact with your baby's body. The hip belt must lie as low as possible over your baby's hips.
  • Page 8 CHECKLIST TO ENSURE THAT YOUR BABY IS INSTALLED CORRECTLY IN THE CAR SEAT The straps of the child safety seat are close to the body without constricting the child. The shoulder straps are adjusted correctly. The straps are not twisted. USE IN THE VEHICLE Danger! In an accident, enormous forces occur.
  • Page 9 FITTING YOUR CAR SEAT INTO THE CAR Warning: This car seat can only be fitted into the passenger seat of a car with a lap and diagonal seat belt with no air bag. The type of approved seat belt you must have your child seat Only suitable if the vehicle is fitted with 3-point static, 3-point retractor safety belts, approved to...
  • Page 10 INSTALLATION Adjust the child car seat carrying handle until you hear a "CLICK" against the backrest of the car's back seat. Push the car seat firmly against the car's back seat. Click 2. Feed the lap section of the adult safety belt through the lap belt guides and fasten it in to the car's buckle until you hear a "CLICK".
  • Page 11 You must also ensure that the buckle is correctly fastened. FOR USE AS PART OF THE STOMP TRAVEL SYSTEM Please refer to page 10 of the Stomp instruction booklet for guidance on how to attach the V2 car seat to the Stomp chassis.
  • Page 12 CARE AND MAINTENANCE Cleaning the shell: Use a damp cloth to clean the main body shell. Cleaning the belt lock and harness: Use only a mild hand soap and warm water. Do Not use chemical cleaners and never attempt to bleach or dye webbing.

Table of Contents