Related Manuals for Ickle Bubba ROTATOR
Summary of Contents for Ickle Bubba ROTATOR
- Page 1 ROTATOR 360 spin isofix car seat INSTRUCTIONS FOR USE ECE R44/04 GROUP 0+/1/2/3 (0-36kg)
- Page 2 WARNINGS! WARNING: The correct routing of the seat belt is essential for your child’s Item: Rotator Car Seat (newborn to 36kg) safety. Please see the Installation section. Never thread the belt in any Group 0+ (newborn to 13kg / birth to approximatively 12-15 months) other way.
-
Page 3: Warnings
WARNINGS! vehicle. Any straps holding the restraint to the vehicle should be tight. Any straps restraining the child should be adjusted to the child's body, and the straps should not be twisted. NEVER fasten the child restraint on the front passenger seat as air bag deployment will interfere with the safety of the It is important to ensure that any lap strap is worn low down, so that restraint and may cause serious injury or death. -
Page 4: Securing Your Baby
Car Seat Features Securing your baby using the baby insert CAUTION: For the protection of your baby: Headrest and Harness Height Infant Head Insert Adjustment Please use the insert attached to this car seat up to Harness Chest Pads Seat Backrest approximately 13kg. -
Page 5: Installation In The Vehicle
Securing your baby using the harness Installation in the vehicle • Loose the harness straps by pressing the release button and pulling the harness straps as far Please do not leave your child unattended in the child safety seat in the vehicle. as you can. - Page 6 Installation of Group 2/3 (15-36kg) Installation of Group 0+(birth-13kg), Group I(9-18kg) with ISOFIX & Top tether • The top tether strap should go through the belt guides on both sides, then lock the hook on the anchor bracket. • Pull out the top tether and press the tether strap release button to extend the strap until it is long enough to hook onto the User-ready tether anchorage behind.
-
Page 7: Care And Maintenance
The belt must be routed as shown in the manual. Care and Maintenance Removing the Soft Seat Trim • Press the ISOFIX release button and push the ISOFIX 1. Remove the infant inserts by loosening the harness and pulling them out from around the connectors forward as far as possible. - Page 8 If a returned item is found to have a fault not related to a manufacturing defect, Ickle Bubba reserve the right to charge for any repairs carried out or spares/ replacements provided.
- Page 9 contact@icklebubba.com Atlantic House, Unit 2, Atlantic Close, Swansea SA7 9FJ Unit 125, 3 Lombard Street East, Dublin 2, D02 HC78 www.icklebubba.com...