Table of Contents
Advertisement
Network Setup:
System Operation Mode: Bridge or Router (The default value is Bridge mode)
Bridge: When configured to Bridge mode, the AP acts as bridge to transmit/receive traffic
between LAN to Wireless LAN. And there is only one IP address available for the system.
Router: When configured to Router mode, the AP acts as Router, the LAN and Wireless LAN will
be separated to different network. See Router Mode – WAN/LAN Setup for detail configuration.
Bridge Mode - IP Setup
IP Address: Once Static IP was selected, the IP Address field will allow you to set the bridge
device IP address manually. This IP address of the bridge is used as the base for all of your local
Chapter 5 Management
Figure 77 Network Setup
Page 18
Advertisement
Table of Contents
