Summary of Contents for Silicon Laboratories Si8284-EVB
Page 1
UG168: Si8284-EVB User's Guide This document describes the operation of the Si8284-EVB. KEY POINTS The Si8284 Evaluation Kit contains the following items: • Discusses hardware overview and setup, • Si8284-EVB including: • Si8284 low voltage side connections. • Si8284CD-IS installed on the evaluation board.
1. Overview and Setup 1.1 Hardware Si8284-EVB can be used to demonstrate the isolated gate drive capabilities of the installed Si8284CD-IS. The Si8284 includes a DC- DC converter used to supply isolated power to the gate driver. Si8284 Low Voltage Side Connections Supply power to the input side of Si8284 by applying 12 to 24 VDC to VDDP at terminal block J1.
Page 3
UG168: Si8284-EVB User's Guide Overview and Setup 1.2 Alternative Configurations Positive Voltage Gate Drive Only The standard configuration for the gate driver to apply positive voltage, VDDB-VMID, to the gate during the high drive portion of the PWM cycle and negative voltage, VSSB-VMID, during the low drive portion of the PWM cycle. Alternatively, if only positive drive voltage is desired, remove R13 and install a 0 Ω...
Page 5
UG168: Si8284-EVB User's Guide Schematics VPWR 1. DC/DC is built to drive gate to +15/ -9V 2. To operate with positive gate drive only: VPWR a. Remove R13 b. Install R19 = 0 Ohm VDDA VDDB c. Change divider VDDB-VSSB = (R1/R2 + 1) x 1.05V...
Need help?
Do you have a question about the Si8284-EVB and is the answer not in the manual?
Questions and answers