Installing The Subrack; Prerequisites; Subrack Installation - ABB FOX615 Installation & User Manual

3.6.3

Installing the subrack

3.6.3.1

Prerequisites

3.6.3.2

Subrack installation

Subrack installation Proceed as follows:

FOX615 Installation
Before you mount the subrack, please make sure that the installations of the
• Captive nuts (19-inch racks only),
• ETSI adapters (ETSI racks only),
• Cable tray with power cables,
• Power supply circuits
(Optionally with 2 power supply circuits if the DUPF1 option for dual
power supply is installed),
• Signal cables,
• DUPF1 option (if applicable) for dual power supply is installed on the sub-
rack, and
• FAMO1 or FAMO1-F power and alarm
are complete and checked.
Please note:
A subsequent installation of the DUPF1 and/or FAMO1 or FAMO1-F power
and alarm cable is not possible without service interruption and requires sub-
stantial installation effort!
The installation of the DUPF1 and/or FAMO1 or FAMO1-F power and alarm
cable requires unlimited access to the bottom rear of the FOX615 subrack.
This access is normally only possible with unplugged signal cables and if the
subrack is removed from the rack.
The steps to install the subrack are as follows:
1. Locate the fixing position of the subrack in the 19-inch rack or within the
ETSI adapters above the FOX cable tray.
2. Lift the subrack into position and secure the subrack using four M6
screws.
3. Ensure that the FAMO1 or FAMO1-F power and alarm cable stays free
within the cable tray and leaves with the FAMO1 or FAMO1-F connector
to the front of the subrack.
Optionally:
Ensure that the DUPF1 alarm interface cable stays free within the cable
tray and leaves with the DUPF1 connector to the front of the subrack.
4. Ensure that the power cable(s) stay(s) free within the cable tray and
remain accessible from the front.
5. Tighten the M6 screws provisionally.
End of instruction
I N S T A L L A T I O N P R O C E D U R E S
cable, option (if applicable)
57