NARVI NME 450 Installation Manual

INSTALLATION MANUAL
GB
ELECTRICAL SAUNA STOVES - NME 450, NME 600, NME 900
1. THE ELECTRICAL SAUNA STOVE PACKAGE INCLUDES:
- Sauna stove jacket
- Stone basket with control device
- Mounting plate + anchor screws
- Installation instructions
2. BEFORE INSTALLATION
Check the following:
- The sauna stove is the right size (kW) for the size of the sauna (cu m).
- Table 1 shows the volumes of the sauna for the different types of stoves.
- If the sauna has non-insulated surfaces, for instance brick, tile or glass, 1.5 cu m must
be added to the sauna volume for each square metre of wall on the basis of which the
effect needed for the sauna stove is defined according to Table 1.
The volume values of the sauna according to Table 1 must not be exceeded
or lowered.
- The minimum height of the sauna and the distances of the minimum protected areas
have been defined in Table 1.
- Make sure that there is a sufficiently steady mounting plate for the anchor screws.
A thin panel alone is not enough. Additional supporting rails behind the panel or
reinforcement boards on the top of the panel which are fastened to the wall support can
be a reinforcement.
- Sauna stoves NME-450 and 600 can also be installed in a wall recess where the
protected areas must be considered according to Figure 1.
- Stove NME-900 must allowed to be installed in the wall recess.
ONLY ONE ELECTRICAL STOVE MUST BE INSTALLED IN THE SAUNA.
Scale 1. Installation data for the sauna stove NME
Stove modell Effect Steam room
Volyme
min
m 3
kW
NME 450 4,5 4
NME 600 6 6
NME 900 9 9
Minimum protection distances to the stove
Height Sides In front
max min A **) B **)
m 3
cm cm cm
7 190 5 5
9 190 5 8
15 190 10 10
**) See Figure 1
In front Ceiling Floor
C **) D **) E **)
cm cm cm
2 115 12
2 115 12
2 115 12
*) The rubber cable H07RN-F or similar as a connection able
Stone amount Connection*)
400V 3N
mm 2
kg
30 5x1,5
30 5x1,5
30 5x2,5
Fuses
A
3x10
3x10
3x16