Panasonic FP2 Technical Manual page 35

FP2 Multi-wire Link Unit
2.2.3 Mode Selector Switches (2)
(Rear)
When the unit is shipped from the factory, all switches are set to the "OFF" position.
The contents of the mode selector switches (2) are indicated by the status indicator LEDs.
No. Item No Item
1
Operation mode Operation mode
2
setting
Communication
3
speed (* Note 1)
4
———————
. Notes
D (*1): When the W2 mode is set, 500 kbps and 250 kbps setting
D The settings of the mode selector switches (1) and (2) should
always be changed with the power off. The setting will be ef-
fective the next time that the power is turned on. (If the setting
is changed with the power on, be aware that the setting in ef-
fect when the power was turned on will remain effective.)
D Only the settings of the mode selector switches (1) No. 7 and
No. 8 (terminal station settings) will be effective at the instant
that they are changed.
Operation mode(W/W2/F mode selection)
Communication speed(W2 mode only)
Setting contents
W mode
OFF OFF ON ON
500kbps (fixed)
This should always be secured at "OFF" when being used.
units should not be mixed in the same network.
W2 mode
OFF ON
OFF ON
OFF ON
250kbps
500kbps
Parts and Its Functions
2.2 Switch Settings
F mode
OFF ON
500kbps (fixed)
2 - 9