GE Druck DPI 832 User Manual page 7

Table 5: Menu options - Settings (Output)
Options Description
To select and set up a value for the "Nudge"
output. Example: 1.000mA increments.
Additional data: Select Settings (
To select and set up values for the "Span Check"
output. Example output cycle:
Additional data (Table 6): Select Settings (
To select and set up values for the "% Step" output.
% Step
Example output cycle:
Additional data (Table 6): Select Settings (
To select and set up values for the "Defined Step"
... Step
output. Example output cycle:
Additional data (Table 6): Select Settings (
To select and set up values for the "Ramp" output.
Example output cycle:
Additional data (Table 6): Select Settings (
K393 Issue 1
)
This cycle repeats
automatically.
)
Auto Repeat - Optional
)
Auto Repeat - Optional
)
Auto Repeat - Optional
)
Table 6: Additional data for Settings (Output):
Item Value
Span Check
Low (0%) Set the 0% value.
High (100%) Set the 100% value.
Dwell (d) Set the period (Hours:Minutes:Seconds) between
each change in value.
% Step Low (0%), High (100%), Dwell (d): As above.
Step Size (s) ... Set the change in value for each step as a
% percentage of the full-scale range (High - Low).
Defined Step Low (0%), High (100%), Dwell (d): As above.
Step Size (s) Set the change in value for each step in mA, mV or
Volts.
Ramp Low (0%), High (100%), Dwell (d): As above.
Travel (t) Set the period (Hours:Minutes:Seconds) to go from
the Low (0%) value to the High (100%) value.
Auto Repeat If applicable, select this item to repeat a cycle
continuously.
[EN] English - 5