5.7
Connecting to the Alarm Relay Panel
Use the provided Alarm Relay Serial Cable to connect the PS71090 Public Safety Signal Booster to the
alarm relay panel. If the provided cable is not long enough for your system, you will need to build
one.
1.
2.
3.
©2017 Westell Technologies
1.877.844.4274
Strip the outer serial cable insulation back to expose the inner conductors, Figure
5-3.
Strip back the insulation on the ends of each conductor. (Tin wires as needed.)
Figure 5-3: Stripped Alarm Wire
Remove the protective cover on the Alarm Relay 9 position D-Sub connector.
Figure 5-4: Alarm Relay 9 Position D-Sub Connector
PS71090 Product Manual
March 2017, Rev G
WESTELL.COM
March 2017; Doc No. CS14702802UM rG
Page 29 of 50