Connecting To The Alarm Relay Panel; Figure 5-3: Stripped Cable Conductors; Figure 5-4: Alarm Relay 9 Position D-Sub Connector - Westell Technologies PS71090-P8 User Manual

5.7

Connecting to the Alarm Relay Panel

Use the provided Alarm Relay Serial Cable to connect the PS71090-P8 Public Safety Signal Booster to
the alarm relay panel. If the provided cable is not long enough for your system, you will need to build
one.
1.
2.
3.
©2017 Westell Technologies
1.877.844.4274
Strip the outer serial cable insulation back to expose the inner conductors, Figure
5-3.
Strip back the insulation on the ends of each conductor. (Tin wires as needed.)
Figure 5-3: Stripped Alarm Wire
Remove the protective cover on the Alarm Relay 9 position D-Sub connector.

Figure 5-4: Alarm Relay 9 Position D-Sub Connector

PS71090-P8 Product Manual
March 2018, Rev A
WESTELL.COM
March 2018; Doc No. CS14000802UM rA
Page 29 of 52