5.4
Mounting the Signal Booster
Follow the instructions in this section to mount the Signal Booster on a wall.
1.
2.
3.
4.
5.
©2017 Westell Technologies
1.877.844.4274
Figure 5-1: Signal Booster Mounting
Using the PS71090 as a template, mark the four (4) locations for the wall
anchoring system screws.
Move the PS71090 unit and drill the mounting holes at the marks in the wall.
Install a wall anchor in each of the four (4) drilled holes.
Install the top two (2) screws into the anchors, leaving enough room to slide the
screws into the oblong holes of the top of the unit's mounting positions.
Once the Unit is hung on the top two (2) screws finish fastening the top screws.
Install the bottom two (2) screws into the anchors, fastening the Unit to the wall.
PS71090 Product Manual
March 2017, Rev G
WESTELL.COM
March 2017; Doc No. CS14702802UM rG
Page 27 of 50