Mounting The Signal Booster - Westell Technologies PS71090E User Manual

To determine the quantity and locations of indoor antennas, measure Received Signal
•
Strength Indication (RSSI) using DM Tool software to determine areas of weak signals. These
are the approximate areas where indoor antennas may be needed.
Be aware that the signal from an indoor antenna, in most cases, can be expected to penetrate
•
approximately two standard sheet rock walls to reach users. If the signal must travel through
more than two walls, or if the walls are made of materials other than sheet rock, it may be
necessary to split the available signal and add more antennas.
5.4

Mounting the Signal Booster

Follow the instructions in this section to mount the Signal Booster on a wall.
1.
2.
rD
1.877.844.4274
Figure 5-1: Signal Booster Mounting
Using the PS71090E as a template, mark the four (4) locations for the wall
anchoring system screws.
Move the PS71090E unit and drill the mounting holes at the marks in the wall.
PS71090E Product Manual
October 2019, Rev A
WESTELL.COM
©2019 Westell
Technologies
Doc No. CS14702802UM
September 2019;
Page 30 of 61