Turning On Or Off - Yamaha EAD10 Owner's Manual

 Connecting a Computer
If you have a computer and DAW software, connect the Main Unit to the computer and you can record your performance
and listen to the playback from the computer. For more information, refer to the Reference Manual (Advanced) (PDF).
Precautions when using the [USB TO HOST] terminal
When connecting the computer to the [USB TO HOST] terminal, make sure to observe the following points. Failing
to do so risks freezing the computer and corrupting or losing the data.
If the computer or the instrument freezes, restart the application software or the computer OS, or turn the power to
the EAD10 off then on again.
NOTICE
• Use an AB type USB cable of less than 3 meters. USB 3.0 cables cannot be used.
• Before connecting a computer to the [USB TO HOST] terminal, disable any power-saving mode of the computer
(such as suspend, sleep, or standby).
• Execute the following before turning the power to the instrument on/off or plugging/unplugging the USB cable to/
from the [USB TO HOST] terminal.
- Quit any open application software on the computer.
• While the computer is connected to the EAD10, you should wait for six seconds or more between these opera-
tions: (1) when turning the power of the EAD10 off then on again, or (2) when alternately connecting/disconnect-
ing the USB cable.

Turning On or Off

 Turning On
CAUTION
Do not reconnect cables between the Main Unit and Sensor Unit after turning the power on. Doing so will cause noise.
1.
Turn the [MASTER VOLUME] knob fully
counterclockwise to lower the Main Unit vol-
ume to its minimum.
2.
Press the [ ] (Standby/On) switch.
The startup screen appears in the LCD.
Setup Guide
Turning On or Off
May differ from the actual specifica-
tions.
EAD10 Owner's Manual 25