Yamaha EAD10 Owner's Manual page 22

Setup Guide
Setting Up
 Attaching the Sensor Unit
Attach the Sensor Unit to the top of the batter side bass drum hoop.

Standard Straight Hoop
Wood hoops
1.
Slide the Sensor Unit onto the top of the batter side bass drum hoop as far as possible.
2.
Lift the Sensor Unit and after making sure both surfaces shown in the figure below are in
contact with the hoop, turn the clamp screw.
Tighten the clamp screw firmly, making sure that the Sensor Unit is secure and not loose.
Side view
1
Top of the
Hoop
batter side

Other Hoop Types
Metal hoops
Uneven profile type
1.
Attach the included adhesive cushions,
one each to the top of the inner and
outer hoop surfaces.
NOTICE
Make sure the uneven surface is filled with adhe-
sive cushions to provide a secure attachment for
the sensor. The Sensor Unit may fall off if the
adhesive cushions is not used.
2.
Attach the sensor using the same procedure as for a standard hoop drum.
18 EAD10 Owner's Manual
2
(cross section)
Adhesive
cushion
Clamp
screw
Make sure these two
surfaces are in con-
tact with the hoop
Make sure this sur-
face is in contact
with the hoop
(cross section)