Yamaha EAD10 Owner's Manual page 25

 Taking Measures Against Noise
To eliminate the cause of the noise, adjust positions beforehand so that your toms do not touch the Sensor Unit or that the
Connector Cables do not move around the Sensor Unit during your performance.

Check the Sensor Unit Location
Make sure the Sensor Unit does not touch the toms or other
instruments.

Securing the Cables
Position the L-shaped plugs connected the Sensor Unit on their
sides. This provides a more stable cable position.
Use the Cable band to secure the Connector Cables close to the
Sensor Unit.
When mounting the Main Unit on a hi-hat stand, use the Cable
band to keep the cables from interfering with the foot pedal.
Example of poor placement
Viewed from above
Hoop
Viewed from above
Setup Guide
Setting Up
Viewed from the
Sensor Unit jack side
Cable band
Cable band
EAD10 Owner's Manual 21