Polaris Scrambler 1000 Owner's Manual page 42

Hitches
Hitch Removal/Installation
1. To remove the hitch, remove the cotter pin and hitch pin. Remove
the hitch, then reinstall the hitch pin and secure the cotter pin.
Hitch Pin
Cotter Pin
2. To install the hitch, remove the cotter pin from the hitch pin and
remove the hitch pin.
3. Install the hitch to the receiver.
4. Reinstall the hitch pin (from the left side of the hitch) through the
bore of both the receiver and the hitch.
5. Reinstall the cotter pin. Make sure the hitch assembly is secure at
that the cotter pin is properly engaged over the hitch pin.
7-Way Trailer Connector (Zugmachine)
The 7-way trailer connector
installed on your vehicle meets the
requirements of European standard
ISO 1724.
This connector uses all 7 pins on
newer model trailers. An older
model trailer may not be
compatible with this connector.
Improper electrical wiring changes
can result in damage to both
vehicle and trailer components. When in doubt about your trailer
connection, please contact a qualified towbar specialist for assistance.
FEATURES AND CONTROLS
Step 4
7-Way Trailer Connector
Step 5
41