Section 5-Front Riggings; Installing/Removing Front Riggings - Invacare Concept 45 User Manual

5 FRONT RIGGINGS
5 Front Riggings
WARNING
After any adjustments, repair or service and before use, make sure all attaching hardware is tightened securely. Otherwise
injury or damage may occur.
5.1

Installing/Removing Front Riggings

Installing
1. Turn the front rigging assembly to the side (open front rigging is perpendicular to wheelchair).
2. Install the hinge plates of the front rigging assembly onto the hinge pins on the wheelchair frame.
 When performing STEP 3, it may be necessary to pull release lever toward front of chair to assist the front rigging to lock
in place.
3. Push the front rigging assembly towards the inside of the wheelchair
until it locks into place.
 The footplate will be on the inside of the
wheelchair when locked in place.
4. Repeat this procedure for the other front rigging assembly.
5. To release the front rigging, push the front rigging release lever
inward, rotate front rigging outward.
Removing
1. Push the front rigging release lever inward.
2. Rotate swingaway front rigging assembly outward.
3. Lift the swingaway front rigging assembly off the hinge pins.
®
Invacare Concept 45 Wheelchair
Front Rigging Assembly
Hinge
Pins
Front Rigging
Release Lever
Hinge Plates
FIGURE 1 Installing/Removing Front Riggings
34
 Swingaway footrest
shown.
Footplate
Part No. 1088191