Table of Contents
Advertisement
IC Live Users Manual - Models ICL-R & IC215S-R
The next step is to connect the
-
green Tx triangles and then double
click on one of the loudspeaker's
red Rx triangles to connect the two.
A connection line will let you know
the connection was completed. The
loudspeaker's Receiver automati-
cally inherits the bundle settings of
repeating these steps until all the
loudspeakers are connected.
To correct a mistake or change an
assignment, double click on the
Receiver whose assignment you
want to change or right-click on the
Receiver Icon and select Disable
Receiver from the menu that pops
up. Either method will break the
connection and allow you to make a new one.
Once your Tx and Rx bundle as-
signments have been made, open
each loudspeaker's Properties
window by double-clicking its icon.
If the window does not open in
Connect mode, click on the Connect
tab at the top to display the window
shown at the right.
In the lower-right section of this
window, you make channel as-
signments by clicking and drag-
ging to connect audio channels
Receivers.
You can also assign Outputs 1 and
2 (selected in the upper section un-
Transmitters.
29
Advertisement
Table of Contents
