Operation With No Pc; Presets - Rhaon ICL-R User Manual

Operation With No PC

be inoperative. Your connections need to be made to the lower Master module. You also need to make sure the CAT5 linking signal cable
and the short AC power cable that links the two modules together are in place.
We'll start with a system that will be run without a computer.
1.
2. Check the preset digital readout display to make sure the correct preset is selected. On single ICL-R arrays:
Preset 10:
should not be used during normal operation.
Preset 11: is factory installed and locked for small venues needing only a 50 foot
throw
Preset 12: is factory installed and locked for venues needing a 75 foot throw
Preset 13: is factory installed and locked for venues needing a 100 foot throw
Preset 14:
factory and was not locked. It may have been deleted and replaced by a
user installed preset
Presets 15,16, 17, 18 & 19 are set aside for user installed presets.
Preset 20:
should not be used during normal operation.
Preset 21: is factory installed and locked for venues needing a 100 foot throw
Preset 22: is factory installed and locked for venues needing a 125 foot throw
Preset 23: is factory installed and locked for venues needing a 150 foot throw
Preset 24:
factory and was not locked. It may have been deleted and replaced by a user
installed preset
Presets 25,26, 27, 28 & 29 are set aside for user installed presets.
3.
4.
it is selected.
5. Check the setting of the Input Pad. The pad should be inserted if your analog input source has a high output level. When On, a 10 dB
is inserted.
6.
readout will display the level setting in dB. You can also mute the output by pressing the Mute button.
Important: The factory presets do not include any EQ, high or low frequency shelving, delay or compression. These can be
added to the presets using a PC equipped with RHAON. Refer to page 16 for details.
IC Live Users Manual - Models ICL-R & IC215S-R
11