Quidway S5012G-DC Installation Manual page 6

Installation Manual
Quidway S5000 Series Ethernet Switches
Table 1-2 Port status mode indicators of S5012G switch
Description
Port status
mode
indicator
Note:
"-" stands for undefined.
The control button MODE is in fact a switch. With it, you can convert cyclically port
status mode indicators, in order of L/A---D/C—SPD. Only the selected indicator is
on. The MODE button facilitates you to query and analyze port status. For example,
if you want to query connection status at a port, you can turn on the L/A indicator
with the MODE button and observe the status of the corresponding indicators. Then
you can determine current connection status of the port by reference to the
correlation listed above.
The L/A indicator is on when the switch is initialized after power-on.
Indicator Status
ON
L/A
OFF
(Link
/Active)
Blinkin
g (4Hz)
ON
D/C
OFF
(Duplex/
Collision)
Blinkin
g (4Hz)
OFF
SPD
ON
(Speed)
Blinkin
g (4Hz)
Huawei Technologies Proprietary
1-4
Chapter 1 Product Overview
Status Description
10/100/1000M
electric port (copper
wire)
The port is connected to the peer device and
the link is normal.
The port is not connected to the peer device
or the link fails.
The port is transceiving data.
The port runs in full duplex mode.
The port runs in
-
half duplex mode
The port in
-
conflict
The port runs at
the rate of -
10Mbps
The port runs at
the rate of -
100Mbps
The port runs at the rate of 1000Mbps
1000M optical port
(optical fiber)