Table of Contents
Advertisement
Installation Manual
Quidway S5000 Series Ethernet Switches
Figure 5-5 "Sending File" Interface
After completing the loading, the system displays the following information:
Loading ...CCCCCCCCCC done!
## Total Size
Your baudrate should be set to 9600 bps again!
Press enter key when ready.
Note:
You do not need to reset the HyperTerminal's baud rate and can skip the last step if you
have chosen 9600 bps. In this case, the system does not display the above prompt
message but "BootROM is updating now.....................................done!" instead.
Step 10: Reset HyperTerminal's baud rate to 9600bps with reference to Steps 5 and 6
described above. Then, press any key as prompted. The system will display the
following information when it completes the loading.
Bootrom is updating now.....................................done!
III. Loading host software
Follow these steps to download the host software of the switch:Step 1: Select <1> in
Boot Menu. The system displays the following information:
1. Set TFTP protocol parameter
2. Set FTP protocol parameter
3. Set XMODEM protocol parameter
0. Return to boot menu←
Enter your choice(0-3):3
Chapter 5 BootROM and Host Software Loading
= 0x00055d40 = 351552 Bytes
Huawei Technologies Proprietary
5-7
Hide quick links:
Advertisement
Table of Contents
