Ignition Switch; Cutting Methods; Important Points - Poulan Pro 530087857 Operator's Manual

STARTING
WARNING:
The chain must not move
when the engine runs at idle speed. If the
chain moves at idle speed refer to
within this manual. Avoid
TOR ADJUSTMENT
contact with the muffler. A hot muffler can
cause serious burns.
To stop the engine move the switch to the
STOP or OFF position.
To start the engine hold the saw firmly on
the ground as illustrated. Make sure the
chain is free to turn without contacting any
object.
Use only 15"---18" of rope per pull.
Hold saw firmly while pulling starter rope
Important points to remember
When pulling the starter rope, do not use
the full extent of the rope as this can cause
the rope to break. Do not let starter rope
snap back. Hold the handle and let the rope
rewind slowly.
NOTE: Do not attempt to cut material with
the fast idle lock button in the locked posi-
tion.
For cold engine or warm engine after
running out of fuel:
Move switch to the START or ON posi-
S
tion.
Pull choke knob out to the full extent.
S
Slowly press primer bulb six times.
S
Squeeze and hold throttle trigger. With
S
thumb press fast idle lock down; then
release throttle trigger.
Sharply pull the starter rope handle 5
S
times with your right hand.
Fully push in choke knob; pull the start-
S
er rope until the engine starts.
Allow the engine to run for approxi-
S
mately five seconds. Then, squeeze
and release throttle trigger to allow en-
gine to return to idle speed.
Fast idle lock down

IGNITION SWITCH

CARBURE-
(SIDE VIEW)
Choke Knob
For a warm engine:
Fully push in choke knob.
S
Move switch to the START or ON posi-
S
tion.
Slowly press primer bulb six times.
S
Squeeze and hold throttle trigger. With
S
thumb press fast idle lock down; then
release throttle trigger.
Sharply pull the starter rope with your
S
right hand until the engine starts.
Squeeze and release throttle trigger to
S
allow engine to return to idle speed.
Difficult starting or flooded engine:
The engine may be flooded with too much
fuel if it has not started after 10 pulls.
Flooded engines can be cleared of excess
fuel by following the warm engine starting
procedure listed above. Insure the ignition
switch is in the ON or START position.
Starting could require pulling the starter
rope handle many times depending on how
badly the unit is flooded. If engine fails to
start, refer to troubleshooting chart or call
1-800-554-6723.

CUTTING METHODS

IMPORTANT POINTS

Cut wood only. Do not cut metal, plas-
S
tics, masonry, non-wood building mate-
rials, etc.
Stop the saw if the chain strikes a for-
S
eign object. Inspect the saw and repair
or replace parts as necessary.
Keep the chain out of dirt and sand.
S
Even a small amount of dirt will quickly
dull a chain and thus increase the possi-
bility of kickback.
Practice cutting a few small logs using
S
the following techniques to get the
"feel" of using your saw before you be-
gin a major sawing operation.
Squeeze throttle trigger and allow
S
engine to reach full speed before
cutting.
Begin cutting with the saw frame
S
against the log.
Keep the engine at full speed the
S
entire time you are cutting.
7
SIDE VIEW
ON
STOP
CHOKE
OFF FULL