Configuring System With Connected Telephone; Installation Sequence - Davolink DV-201DM User Manual

DV-201DM for H.323 & SIP

2.4 Configuring system with connected telephone

2.4.1 Installation sequence

1. Hardware Installation & Cable connection
Place on flat surface and make sure that rubber feet are attached. (for cooling
system)
Following figure shows the cable's connections
2. System Configuration
CAUTION : In system configuration procedure at start, please eject a PSTN line
cable.
System configurations of DV-201DM consist of following 2 parts.
- Internet setting : For PPP Connection, consist of the ISP phone number, user ID
and password.
- VOIP setting : For Internet telephony, you should set Proxy Server or Gatekeeper
and telephone number and so on.
You can configure by using a telephone connected to TEL port and Web browser
of your PC. Configuration by telephone can be applied if you can not connect to DV-
201DM by web browser. We recommend using Web browser.
- Using telephone
When you have configured system. Please inject a PSTN line. Make restart DV-
201DM by power switch and wait about 20~30 seconds until system is initialized.
3. Using VOIP service
If you hear the dial tone at off-hook the telephone, you can use internet telephony.
Else Wait for connecting to internet.
If you have problem with our system, please check system configurations or call
us +82-31-387-3240.
For a normal operation of DV-201DM, it takes about 30 seconds after power up. You
2 - 50
: please refer page 2-49,50.