Davolink DV-201DM User Manual page 62

DV-201DM for H.323 & SIP
Protocol
Parameters
RTP Parameters
Manual RAS
Config
3. Available commands
Commands
SHOW
CONFIGURE
SHOW
This command displays the set up value of the H.323 Parameter.
For detailed example, execute "show" from the "DV_GW/CONFIG/VOIP>" prompt
to verify it.
[Example]
DV_GW/CONFIG/VOIP> show
* RAS Parameters *
------------------------------------------------------------------
Gatekeeper not used.
* Registration Numbers *
-------------------------------------------------------------------
200
204
2 - 46
Q.931 Call Signaling
Channel Listen Port
Audio codec type
Fast Connect Used
H.245 DTMF Message
Fast Audio Connect
Force RBT to network
H.245 Tunneling
BRQ Used
NAT Used
Discard non-fast alert
Using H.245 start
(outbound)
# Frame/Packet
Manual RAS
Shows VOIP parameter.
Changes VOIP parameter.
201
205
Q.931 Call Signaling Port number when called.
Codec set used for a call set-up.
Use or not of the fast-connect protocol
Method of sending DTMF in a message format of
H.245
Use or not of the ring back tone from network in
ALERT condition.
The generation mode of a ringing tone to IP network
when the system has received an ALERT message.
Use or not of the H.245 tunneling.
Use or not of the BRQ message.
Use or not of the NAT.
Function of neglecting an ALERT message in a
condition that there is no audio information.
Use or not of the H.245 channel when starting a call.
The numbers of frame per one IP packet.
Use or not of a Manual RAS.
Description
202
206
203
207