Table of Contents
Advertisement
5. CAMERA RE-ASSEMBLY
Make sure all wires are properly connected and
tightened into the terminal blocks, all holes are
sealed against moisture penetration, and all
mounting screws are tight.
Step 5.1 -
Step 5.2 -
Step 5.3 - Use the protruding set-screws in the
Step 5.4 - Press firmly on the dome and rotate
Check that the large "O" ring gasket
in the camera base has not been
dislodged or distorted.
Gently press the camera dome in
place. Move the retaining ring over
the dome.
retaining ring to carefully rotate the
ring clockwise until it is slightly snug,
but not so tight that the ring cannot
rotate further.
the retaining ring until one of the
set-screws aligns with the
adhesive dot on the side of the
dome. Tighten all set-screws with
the supplied Allen key. Refer to
Figure 5-1 on page 25.
24
Advertisement
Table of Contents
