Table of Contents
Advertisement
5. CAMERA RE-ASSEMBLY
If changes were necessary due to voltage and
installation requirements, make sure all power
and video wires are correctly connected and
tightened into their terminal blocks.
Step 5.1 -
Step 5.2 -
Step 5.3 -
Step 5.4 - Make sure the "Top" edge of the
Connect a ¾" NPT gland or conduit
to the open side of the base: Note:
The gland and conduit is not
supplied.
Push the external power/video cable
into the housing and connect to the
power and video of the circuit board.
Check that the large "O" ring gasket
at bottom of the Camera Base
threads is undamaged.
VRB/Camera/LED Chassis is
aligned correctly with the Base.
Refer to Figure 5-1 on page 17.
15
Advertisement
Table of Contents
