Table of Contents
Advertisement
5. CAMERA RE-ASSEMBLY
Make sure all wires are properly connected and tightened
into the terminal blocks, all holes are sealed against
moisture penetration, and all mounting screws are tight.
Step 5.1 - Gently press the camera housing in place. Ensure
the lens is not touching the inside of the viewing
window.
Step 5.2 - Tighten the housing in place with the four security
screws and the supplied Allen key.
Step 5.3 - Wipe the viewing window with a soft cloth to
remove any smudges or dirt.
Step 5.4 - Check the camera for proper operation.
- 13 -
Advertisement
Table of Contents
