Guiding Signals - Dell S518WL User Manual

Guiding Signals

Projector
Status
Standby mode Projector in Standby mode. Ready to
power on.
Warming up Projector takes some time to warm up
mode and power on.
Laser Diode Projector in Normal mode, ready to
on display an image.
accessed.
Cooling mode Projector is cooling to shutdown.
Projector Air vents might be blocked or ambient
overheated temperature may be above 40°C. The
projector automatically shuts down.
Ensure that the air vents are not
blocked and that the ambient
temperature is within operational
range. If the problem persists, please
contact Dell.
Fan One of the fans has failed. The
breakdown projector automatically shuts down. If
the problem persists, please contact
Dell.
Laser Diode Air vents might be blocked or the
driver Laser Diode driver has overheated.
overheated The projector will automatically shut
down. Turn the display on again after
the projector cools down. If the
problem persists, please contact Dell.
Color Wheel Color wheel cannot start. The
breakdown projector has failed and the projector
automatically shuts down. Unplug the
power cord and turn on the projector. If
this problem persists, please contact
Dell.
Laser Diode Laser Diode is defective.
failure
Fault - DC Power supply has been interrupted.
supply (+12V) The projector automatically shuts
down. Unplug the power cord and turn
on the projector. If this problem
persists, please contact Dell.
Description
Note: The OSD menu is not
Control Buttons
TEMP
Power
(Amber)
White Flashing
White
White
White
OFF AMBER
AMBER
OFF
Flashing
AMBER AMBER
AMBER
White
Flashing
OFF
AMBER Flashing AMBER
Troubleshooting
Indicator
LAMP
(Amber)
OFF OFF
OFF OFF
OFF OFF
OFF OFF
OFF
OFF
OFF
AMBER
Flashing
OFF AMBER
AMBER
41