Reset Indicator - Fisher & Paykel RS9120W User Manual

Reset indicator

Use the water filter of your refrigerator as soon as possible after installation. A reset
indicator on the internal control panel and/or external display illuminates when you
need to replace the filter. Reset the indicator only after replacing the filter.
Do not reset the indicator before you change the filter to avoid inaccurate monitoring
1
of filter.
To reset, press the
2
The on the control panel and/or external display will turn off when reset.
3
To disable filter indicator, press
4
will flash once on the internal and external displays.
To turn on the filter indicator again,
5
control panel and external display will flash twice.
Note: do not disable the filter indicator if you have a filter installed. If disabled, the filter
indicator will not alert you of the next filter change. Disable this function only when
there is no filter installed.
IMPORTANT!
The rate of water flow through the water dispenser can slow down as the filter
● ●
cartridge accumulates any sediment which may be present in the water supplied to
your home. This varies depending upon your local water quality, which may require
your filter cartridge to be changed more frequently.
In cases of excessively reduced filter life, we recommend that you consult a local
● ●
plumber or your water supplier for advice on suitable filtration requirements for the
water supplied to your home.
Filter replacement is the consumer's responsibility and will not be covered by the
● ●
Manufacturer's Warranty except in the case of faulty parts or materials within the
filter cartridge.
If the water has not been dispensed for some time or water has an unpleasant taste or
● ●
odour, flush system by dispensing 4L of water.
If unpleasant taste or odour persists, you may wish to fit a new filter cartridge.
● ●
20
OPERATING INSTRUCTIONS
and + buttons for 4 seconds on the control panel.
, and
,
buttons for 4 seconds to turn it off. The
and buttons for 4 seconds, The on the