Coaxial Cable Installation - UTStarcom UTS-600FSU Instruction Manual

Coaxial Cable Installation

Once the locations for the antenna and the main unit have been determined, use the
procedures in this section to install the cable.
Figure 2-1: Stripped Coaxial Cable
• Coaxial cable adapter TNC-J/SM-J (optional)
• 5 meters of coaxial cable (optional)
• Power cable
1. Measure and cut a length of cable to fit between the
main unit and the antenna.
2. Run the cable between the main unit and the
antenna.
3. Using the cable stripper, strip both ends of the
coaxial cable. Refer to the figure below for exact
dimensions to strip.
6mm
6mm
3mm
4. Carefully mount the coaxial cable terminals onto the
cable ends.
5. Affix the cable terminals using the crimper.
16