Table of Contents
Advertisement
Figure 2-3: Antenna Bracket Assembly
2. Assemble the FSU antenna by attaching the bracket
to the antenna according to Figure 2-3.
3. After installing the antenna, use the PHS Signal
Analyzer to check the receiving signal level.
Measure the reception level (RX LVL) at the TNC
connector on the FSU. Target values are as
follows:
• RX LVL: more than -78dBm (35dBµV)
• Frame Error Rate: less than 2%
18
Advertisement
Table of Contents
Need help?
Do you have a question about the UTS-600FSU and is the answer not in the manual?
Questions and answers