Epson WF-7210 series User Manual page 50

User's Guide
❏ Wi-Fi Auto Connect
Connects the printer to a wireless (Wi-Fi) network using a computer that is connected to the access
point. Insert the software disc supplied with the printer into the computer, and then follow the on-
screen instructions. When you are prompted to operate the printer, run this menu.
❏ Disable Wi-Fi
Disables the connection by turning off the wireless signal without deleting the network information.
To enable the connection, set up the wireless (Wi-Fi) network again.
❏ Wi-Fi Direct Setup
Connects the printer to a wireless (Wi-Fi) network without a wireless router.
Connection Check
Checks the status of the network connection and prints the network connection report. If there are any
problems with the connection, see the report to solve the problem.
Advanced Setup
Make the following detailed settings.
❏ Enter Device Name
❏ TCP/IP Address
❏ DNS Server
❏ Proxy Server
❏ IPv6 Address
❏ NFC
❏ Link Speed & Duplex
❏ Redirect HTTP to HTTPS
Epson Connect Services
Select the menus on the control panel as described below.
Settings > System Administration > Epson Connect Services
Displays whether the printer is registered and connected to Epson Connect services .
Register/Delete:
Register or delete the printer to or from the Epson Connect services.
For registering to Epson Connect, see the following portal website.
https://www.epsonconnect.com/
http://www.epsonconnect.eu
Suspend/Resume:
Select whether to suspend or resumeEpson Connect services.
Status:
Check whether or not the printer is registered and connected to the Epson Connect services.
Preparing the Printer
(Europe only)
50