Using Computer Setup (F10) Utilities - HP Z8 G4 Maintenance And Service Manual

Using Computer Setup (F10) Utilities

Computer Setup can be accessed only by turning the computer on or restarting the system. To access
the Computer Setup Utilities menu, complete the following steps:
1. Turn on or restart the computer.
2. Repeatedly press
You can also press
the Computer Setup utility.
NOTE:
repeatedly press
3. A choice of four headings appears in the Computer Setup Utilities menu: Main, Security, Advanced, and UEFI
Drivers.
4. Use the arrow (left and right) keys to select the appropriate heading. Use the arrow (up and down) keys to
select the option you want, then press Enter. To return to the Computer Setup Utilities menu, press Esc.
5. To apply and save changes, select Main > Save Changes and Exit.
● If you have made changes that you do not want applied, select Ignore Changes and Exit.
To restore settings from the Advanced and Main menus to original values, select Apply Factory
●
Defaults and Exit.
To restore settings from the Advanced and Main menus to those previously saved by Save Custom
●
Defaults, select Apply Custom Defaults and Exit. If no custom defaults have been saved, then factory
defaults are used.
NOTE:
Restore Security Settings to Default at the bottom of the Security menu.
NOTE:
CAUTION:
because the settings could become corrupted. It is safe to turn off the computer only after exiting the F10 Setup
screen.
38 Chapter 5 Computer Setup (F10) Utility
F10 when the monitor light comes on to access the utility.
Esc to a menu that allows you to access different options available at startup, including
If you do not press F10
F10 when the monitor light comes on to access the utility.
Settings in the Security menu are not modified by Apply Defaults. Those values are reset by
Not all settings shown in the following sections are available for all models
Do NOT turn the computer power OFF while the BIOS is saving the Computer Setup (F10) changes
at the appropriate time, you must restart the computer and again