Table of Contents
Advertisement
64
format, and the video output will be downconverted (this includes appropriate
color space conversion from HD to SD).
7
If the
output for an HD sequence is downconverted to NTSC or PAL, select one of
the following settings for the video output:
16x9 Letterbox
$
by adding black bars at the top and bottom of the picture for display on a
standard 4:3 television screen.
$
compressed 4:3 video, which retains the picture's full vertical resolution
for display on a widescreen television. To display the video with the
correct proportions on an NTSC or PAL monitor, select the 16:9 display
setting on the monitor.
8
If the
want to be applied to your output video (
2:3:3:2
output format, a pulldown method may automatically be selected.
9
Select
video output to exceed the standard maximum white level. Select
Super Black
below the standard black level.
¦ Note
your final video production for broadcast.
10
Under
NTSC analog video (this affects both the input and output):
0 IRE
$
when working with a commercial DV device that uses the Japanese
analog NTSC setup of 0 IRE. For example, if the video appears too bright
when you play back DV clips on your NTSC monitor, you can change the
setup to 0 IRE to output your DV clips at the correct brightness.
$
11
Under
adjustments to your video output:
$
with respect to the horizontal sync of your genlock source (for composite
video only).
$
SDI video output.
12
Click
box.
Chapter 7, Defining Your Adobe Premiere Pro Settings
Aspect Ratio Conversion
Outputs the widescreen 16:9 picture in letterbox mode
Anamorphic
Outputs the widescreen 16:9 picture as horizontally
Pulldown Method
list is available, select the pulldown method you
). Depending on your sequence's frame rate and the current master
Allow Super White
to allow the lowest luminance level of your video output to fall
Super white and super black should not be allowed when producing
Analog Setup (NTSC)
Applies a setup level of 0 IRE. You should select this option only
7.5 IRE
Applies the standard NTSC setup level of 7.5 IRE.
Advanced Settings
, use the following sliders to make timing
Advances or delays the video output's subcarrier phase
SC/H Phase
SDI Horizontal Delay
OK
to save your settings and return to the
list is available, such as when the video
Standard 2:3
to allow the highest luminance level of your
, select the setup level you want for your
Advances or delays the horizontal timing of the
or
Advanced
Allow
Sequence Settings
dialog
Advertisement
Table of Contents
