Wireless Lan Configuration - Ricoh PRSPC342DN1 User Manual

Table of Contents

Press the [User Tools] key, and then display the [Network] screen.

[System Settings]

Select the Ethernet speed.

[Ethernet Speed]

Wireless LAN Configuration

• This feature is available only when the optional wireless LAN interface board is installed.

• Ethernet and wireless LAN cannot be used at the same time.

• To use a wireless LAN, you must set the IP address, subnet mask, gateway address, DHCP, Frame

Type (NW), and active protocol. For details, see page 90 "Ethernet Configuration".

• For details about setting items and their default values, see:

• page 255 "Host Interface (SP C340DN)" (for SP C340DN)

• page 291 "Interface Settings" (for SP C342DN)

Configuring a Wireless LAN Using Easy Setup (When Using a Wireless Access Point

Supporting WPS)

If the wireless access point in use supports WPS, the wireless LAN connection settings and security

settings can be automatically configured in Infrastructure mode.

Press the [Menu] key, and then select the setting items using the [ ] or [ ] key.

Select [Host Interface]

Select [Network]

Select [LAN Type]

Select [Wireless LAN]

Select [Wireless LAN Easy Setup]

Select [Push Button Method] or [PIN Code Method]

If you select [Push Button Method], press the WPS button on the wireless LAN access point.

midas-p3_com_operating_instructions_gb_00198499_eng.xml

[Interface Settings]

[Network]

Select the Ethernet speed

Press [OK]

Press [Escape]

Press [OK]

[OK]

Press [OK]

Configuration

Draft 2016/01/18

Table of Contents