Ieee 802.11B (Wireless Lan) Configuration - Ricoh CL1000N Option Setup Manual

H H H H
Hold the antenna cap with the cut
off corners towards you and fit it
over the card.
Note
❒ After finishing installation, you
can check whether the 802.11b
interface unit is installed prop-
erly. Print the configuration
page from the "List/Test Print"
menu. If it is installed properly,
you will see "IEEE 802.11b" for
"Controller Option".
❒ If the 802.11b interface unit is
not installed properly, reinstall
B
it from step
stall it properly even after attempt-
ing reinstallation, contact your
sales or service representative.
Reference
For printing the configuration
page, see "Printing a Configura-
tion Page", Administrator Refer-
ence.
AAL158S
. If you cannot in-
Installing IEEE 802.11b Interface Unit Type D
IEEE 802.11b (Wireless LAN)
Configuration
Configure the printer for using the
IEEE 802.11b (Wireless LAN). The fol-
lowing table shows the control panel
settings and their default values.
These items are included in the "Host
Interface" menu.
Setting Name
Comm. Mode
Channel
Trans. Speed
SSID
WEP Setting
Note
❒ In order to use the IEEE 802.11b
(Wireless LAN), select "IEEE
802.11b" for "LAN Type" in "Net-
work Setup" of the Host Interface
menu, and then set "IP Address",
"Subnet Mask", "Gateway Ad-
dress", "DHCP", "Frame Type
(NW)" and "Active Protocol" in the
"Network Setup". For more infor-
mation about setting the items in the
"Configuring the Printer for the Net-
work", see Administrator Reference.
❒ The IP address can be set using
Web Image Monitor also. For de-
tails about using Web Image Mon-
itor, see Web Image Monitor Help.
❒ It takes a while for the display to
change after pressing the { { { { U U U U } } } } or
{ { { { T T T T } } } } key. To set a new IP address,
press the { { { { U U U U } } } } or { { { { T T T T } } } } key - releas-
ing immediately - and then make
sure that the display changes.
Default Value
802.11 Ad hoc
• Inch version
(1-11) 11
• Metric version
(1-13) 13
Auto
ASSID
Not Active
1
23